Order Online

back to 1 Chainwheel Kit Installation

CYCLONE DIY Kit Motor power @ 180W, 250W, 360W, 500W, 650W, 900W, 1200W

3 chainwheel kit installation

1.  install mount.
2.  take off both crank arm
3.  take off bottom bracket 
      check out  video below
4.  install new bottom bracket, chainwheel  and crank arm
5.  set the motor and controller position
6.  set idle wheel tension
7.  align motor with chainwheel and tighten all bolts
8.  adjust front derailleur  see video:  http://www.youtube.com/watch?v=1tQxJqGVznM 
9.  install throttle
10. connect all the wires
11. go out, have fun, make a video and put in on Youtube

P.S disconnect the little red wire between the battery and controller when not use
        fully charge battery every 2-3 months when not using the battery

Complete !!!